Hyundai Elantra CN7 Quiz

Front Wheel Hub and Steering Knuckle - Removal

In this manual: Front Wheel Hub and Steering Knuckle - Removal
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read
1special tools


FRONT WHEEL HUB AND STEERING KNUCKLE - COMPONENTS

REMOVAL

1. Remove the front wheel.

2. Remove the cotter pin and loosen the nut securing the drive shaft to the front wheel hub.

3. Remove the disc brake caliper assembly from the steering knuckle and suspend it from the front strut with wire.

4. Remove the wheel speed sensor from the steering knuckle.

5. С помощью специального инструмента (съемник 09568-34000) отсоедините шаровой

5. Using the special service tool (puller 09568-34000), disconnect the ball joint of the tie rod end from the steering knuckle.

To prevent the puller (0956834000) from slipping off, first tie it with a rope or wire.

6. Отсоедините переднюю стойку подвески от поворотного кулака.

6. Disconnect the front strut from the steering knuckle.

7. Disconnect the drive shaft from the wheel hub.

8. С помощью специального инструмента (съемник 09568-34000) отсоедините поворотный

8. Using the special service tool (puller 09568-34000), disconnect the steering knuckle from the lower arm ball joint.

9. Remove the wheel hub and steering knuckle assembly.

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.