Hyundai Genesis DH Quiz
Automatic Transmission System (SBC)

ATF Warmer Repair Procedures

In this manual: Automatic Transmission System (SBC)
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
5steps
~30min
2/5difficulty
Done 0 of 5

Removal

  1. Drain the engine coolant. (Refer to Engine Mechanical System - "Coolant")
  2. Remove the exhaust manifold. (Refer to Engine Mechanical System - "Exhaust Manifold")
  3. Disconnect the oil cooler tube (A).
    • Replace the O-ring (A) before reinstalling the oil cooler tube.
    • After installation, start the engine and check the hose for leaks.
  4. Disconnect the clamp, and then the cooling hose (A).
  5. Remove the ATF warmer (C).
    • Carefully install the clamp so as not to damage the hose.
    • Install the clamp in the correct direction so that it does not interfere with other parts.
    • After installation, start the engine and check the hose for leaks.

Installation

  1. To install, reverse the removal procedure.
    • After checking the fluid level, add fluid to the automatic transaxle. (Refer to Hydraulic System - "Fluid")
    • Fill with engine coolant. (Refer to Engine Mechanical System - "Engine Coolant")

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.