Hyundai Genesis DH Quiz
Body (Interior and Exterior)

Crash Pad Side Trim Assembly Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
4steps
~24min
2/5difficulty
Done 0 of 4

Replacement
  • Be careful not to scratch or dent the airbag trim and the upper door opening trim, as these parts are made of a fragile material (genuine wood).
  • Wear gloves to avoid cutting your hands.
  • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  • When removing interior trim components, use a plastic panel removal tool to avoid damaging the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Using a flat-tip screwdriver or trim removal tool, remove the crash pad side cover [RH] (A).
  2. Loosen the mounting screw, then remove the side garnish assembly [RH] (A).
  3. Disconnect the hazard switch connector (A).
  4. Install in the reverse order of removal.
    • Make sure the connector is properly connected.
    • Replace any damaged clips.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.