Hyundai Genesis DH Quiz
Restraints

Curtain Airbag (CAB) Module Repair Procedures

In this manual: Restraints
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
11steps
~66min
3/5difficulty
0102030405014.711N·mlb·ft
Tightening torque found on this page
Done 0 of 11

Removal

  1. Disconnect the negative battery cable and wait at least 3 minutes before starting work.
  2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly")
  3. Disconnect the curtain airbag harness connector.
  4. After loosening the mounting bolts, remove the curtain airbag.

Installation

  1. Turn the ignition off.
  2. Disconnect the negative battery cable and wait at least three minutes.
  3. Tighten the curtain airbag mounting bolts.

    Tightening torque: 11.8 ~ 14.7 N·m

  4. Connect the curtain airbag connector.
  5. Install the roof trim assembly. (Refer to Body - "Roof Trim Assembly")
  6. Connect the negative battery cable.
  7. After installing the curtain airbag (CAB), check that the system operates correctly: Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then go off.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.