Repair Procedures of Passenger Airbag (PAB) Module

Removal

1. 1
   Disconnect the negative battery cable and wait at least three minutes before starting work.
2. 2
   Remove the crash pad. (Refer to Body - "Crash Pad")
3. 3
   Disconnect the passenger airbag connector (A) and remove the mounting bolts (B).

   

   Place the individual airbag modules with the airbag cover side facing up.

Installation

1. 1
   Disconnect the negative battery cable from the battery and wait at least three minutes before starting work.
2. 2
   Place the passenger airbag on the protective cushion and tighten the passenger airbag mounting bolts (2) (A).

   Tightening torque: 3.9 ~ 5.9 N·m

3. 3
   Install the crash pad. (Refer to Body - "Crash Pad Main Assembly")
4. 4
   Tighten the passenger airbag mounting bolts (B) and connect the connector to the airbag module (A).

   Tightening torque: 7.8 ~ 11.8 N·m

   

5. 5
   Install the glove box housing. (Refer to Body - "Glove Box")
6. 6
   Reconnect the battery negative (-) cable.
7. 7
   After installing the passenger airbag, check system operation: Turn the ignition on; the SRS indicator should illuminate for about six seconds, then go off.