Hyundai Genesis DH Quiz
Body Electrical System

Front Washer Motor Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
22steps
~132min
4/5difficulty
Done 0 of 22

Inspection

Front Washer Motor
  1. After connecting the washer motor to the reservoir, fill the reservoir with water.
    Before filling the reservoir with water, check the filter for foreign material or contamination. If necessary, clean the filter.
  2. Connect the positive (+) battery cable to terminal 2 and the negative (-) battery cable to terminal 1.
  3. Make sure the motor operates normally, the washer motor runs, and water is sprayed from the front nozzles.
  4. If they are not normal, replace the washer motor. [Front and Rear Washer]
    No. Description
    1 Ground
    2 Windshield washer (+)

  5. Disconnect the negative (-) battery terminal.
  6. Drain the washer reservoir until the washer fluid volume is less than 650 cm³.
  7. Check the continuity between terminals No. 1 and No. 2 at each float position. There should be continuity when the float is down. There should be no continuity when the float is up.
  8. If the continuity does not meet the specification, replace the washer fluid level sensor.
Washer Fluid Level Sensor Switch

Removal
  • When servicing the washer pump, be careful not to damage the washer pump seal.
  • Do not operate the washer pump until the washer reservoir is filled. Failure to do so may cause premature pump failure.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the right wheel house cover.
  3. Remove the hose (A) for the washer reservoir inlet.
  4. Disconnect the connector (A).
  5. Remove the washer reservoir inlet (A) after loosening the mounting bolt.
  6. Loosen the mounting bolt (A).
  7. Remove the washer reservoir.
  8. Remove the headlamp washer hose (A).
  9. Disconnect the washer motor connector (A) and the level sensor connector (B).
  10. Remove the washer motor and level sensor switch (B).

Installation

  1. Assemble the washer reservoir.
    Before installing the washer motor, check the filter for foreign material or contamination. If necessary, clean the filter.
  2. Install the washer reservoir.
  3. Connect the washer motor connector and the washer hose.
  4. Install the right wheel house cover.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.