Headlamp Washer Motor Repair Procedures

Removal

When servicing the washer pump, be careful not to damage the washer pump seal. Do not operate the washer pump until the washer reservoir is filled. Failure to do so may cause premature pump failure.

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the right wheel house cover.
3. 3
   Remove the washer reservoir inlet hose (A).

   

4. 4
   Disconnect the connector (A).

   

5. 5
   Remove the washer reservoir inlet (A) after loosening the mounting bolt.

   

   

6. 6
   Loosen the mounting bolt (A).

   

7. 7
   Remove the washer reservoir.
8. 8
   Remove the headlamp washer hose (A).

   

9. 9
   Remove the connector mounting bracket (A) after loosening the screws.

   

10. 10
    Remove the headlamp washer motor (A) after disconnecting the headlamp washer motor connector (A).

    

11. 11
    Disconnect the negative (-) battery terminal.
12. 12
    Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")
13. 13
    Remove the headlamp washer actuator (A) after loosening the mounting bolts, then remove the hose (B).

    

Installation

1. 1
   Assemble the washer reservoir.

   Before installing the washer motor, check the filter for foreign material or contamination. If necessary, clean the filter.

2. 2
   Install the washer reservoir.
3. 3
   Connect the washer motor connector and the washer hose.
4. 4
   Install the right wheel house cover.
5. 5
   Install the headlamp actuator and hose.
6. 6
   Install the front bumper cover.
7. 7
   Connect the negative (-) battery terminal.