Windshield Wiper and Washer Switch Repair Procedures

Removal

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the upper steering column shroud (A). (Refer to Body - Steering Column Shroud Panel)

   

3. 3
   Disconnect the multifunction switch connector (A).

   

4. 4
   Remove the wiper switch (A) by pressing the stopper pin (B).

   When removing only the wiper and washer switch, unlock the wiper switch lock without removing the steering wheel.

   

5. 5
   If necessary to remove the multifunction switch assembly, remove the steering wheel. (Refer to Steering System - Steering Column and Shaft)
6. 6
   Remove the clock spring. (Refer to Restraint System - "Driver Airbag (DAB) Module and Clock Spring")

   

7. 7
   Loosen the screws (2EA) and remove the multifunction switch assembly (A).

   

Installation

1. 1
   Install the multifunction switch.
2. 2
   Install the clock spring and steering wheel.
3. 3
   Install the upper and lower steering column covers.
4. 4
   Install the steering wheel.

Inspection (with GDS)

1. 1
   Select the vehicle model and Body Control Module (BCM), then check the input of the Multifunction Switch (MFSW).
2. 2
   Select Current Data.
3. 3
   Check the current status of the input for each multifunction switch.