Hyundai Genesis DH Quiz
Body Electrical System

Hazard Warning Switch Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
6steps
~36min
2/5difficulty
Done 0 of 6

Inspection

  1. Check the continuity between the terminals. If continuity is not as specified, replace the hazard warning switch.
    No. Description
    1 Battery (+)
    2 Illumination (+)
    3 -
    4 Signal
    5 Indicator Lamp
    6 -
    7 Illumination (-)
    8 GROUND

Removal
  • Wrap the tool with protective tape to remove the hazard switch using a screwdriver or puller.
  • Handle with care during storage and during disassembly/assembly, as it is easily contaminated by grease and oil.
  • Be careful not to scratch or break the trim panel and the upper part of the door trim, as well as the wood grain (real wood) garnish.
  • Be careful not to scratch the door trim and other parts.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the hazard pad side trim. (Refer to Body - Hazard Pad)
  3. Remove the hazard switch (A) after loosening the screws.

Installation

  1. Install the hazard switch.
  2. Install the hazard pad.
  3. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.