Hyundai Genesis DH Quiz
All-Wheel Drive (AWD) System

Radial O-ring Repair Procedures

In this manual: All-Wheel Drive (AWD) System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
5steps
~30min
2/5difficulty
Done 0 of 5

Removal
Be careful when handling the transfer case. Prevention of ITA (Integrated Transfer Actuator) Damage 1) When transporting the transfer case
  • Be careful when lifting the transfer case with a transport package to ensure the ITA does not collide with another transfer case.
  • Be careful not to damage the ITA by contact with the floor or structure.
2) When assembling the transmission
  • Be careful not to damage the ITA by contact with the transmission, floor or structure.
  1. Remove the transfer case from the vehicle. (Refer to All Wheel Drive (AWD) System - "Transfer Case Assembly")
  2. Remove the O-ring (A).

Installation

  1. Blow out the O-ring groove (A) with compressed air.
  2. Install a new O-ring (A).
  3. Install the transfer case on the vehicle. (Refer to All Wheel Drive (AWD) System - "Transfer Case Assembly")
    • After installation, start the engine, then check for leaks from the transfer case.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.