Rear Stabilizer Bar Repair Procedures

Removal

1. 1
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the rear wheel and tire (A) from the rear hub.

   Tightening torque: 88.3 ~ 108 N·m

   

   Be careful not to damage the hub bolts when removing the rear wheel and tire.

3. 3
   Loosen the bolts and remove the cover (A). [TAU]

   Tightening torque: 8.8 ~ 13.7 N·m

   

4. 4
   Using a hex key, loosen the nut (A) while holding the stabilizer link end, then disconnect the link from the lower arm.

   Tightening torque: 98.1 ~ 118 N·m

   

5. 5
   Loosen the mounting bolt (A) and remove the stabilizer bar (B).

   Tightening Torque: 49.0 ~ 64 N·m

   

6. 6
   Disconnect the rear stabilizer link (B) from the stabilizer bar (A).

   Tightening torque: 98.1 ~ 118 N·m

   

7. 7
   Installation is in the reverse order of removal.

Inspection

1. 1
   Inspect the bushing for wear and damage.
2. 2
   Inspect all bolts.
3. 3
   Inspect the stabilizer bar for deformation.