Hyundai Genesis DH Quiz
Suspension System

Rear Crossmember Repair Procedures

In this manual: Suspension System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
21steps
~126min
4/5difficulty
04080120160200107.980N·mlb·ft
Tightening torque found on this page
Done 0 of 21

Removal

  1. Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
  2. Remove the rear wheel and tire (A) from the rear hub.

    Tightening torque: 88.3 ~ 108 N·m
    Be careful not to damage the hub bolts when removing the rear wheel and tire.
  3. Remove the cotter pin, castle nut (A) and washer from the front hub.

    Tightening torque: 196.1 ~ 275 N·m (20.0 ~ 28.0 kgf·m, 144.7 ~ 202.5 ft-lbf)

  4. Remove the rear caliper. (Refer to Brake System - Rear Disc Brake)
  5. Remove the rear brake disc (A).

    Tightening Torque: 4.9 ~ 5.9 N·m

  6. Loosen the bolts and remove the cover (A). [TAU]

    Tightening torque: 8.8 ~ 13.7 N·m

  7. Remove the bracket (A).

    Tightening Torque: 49.0 ~ 64 N·m

  8. Remove the bolt (A) and rubber mounts (B), (C) to separate the muffler.

    Tightening Torque: 49.0 ~ 64 N·m

  9. Remove the rear propeller shaft. (Refer to Drive Shaft and Axle - Rear Propeller Shaft Assembly)
  10. Remove the rear differential housing. (Refer to Drive Shaft and Axle - Differential Housing Assembly)
  11. Remove the parking brake shoe. (Refer to Brake System - Parking Brake System)
  12. Remove the front rear upper arm and rear rear upper arm. (Refer to Suspension System - Rear Upper Arm)
  13. Remove the rear trailing arm. (Refer to Suspension System - Rear Trailing Arm)
  14. Remove the rear lower arm... (Refer to Suspension System - Rear Lower Arm)
  15. Remove the rear lower arm. (Refer to Suspension System - Rear Lower Arm)
  16. Disconnect the EPB connector (A) and cable (B).
  17. Loosen the mounting bolts and remove the rear crossmember.

    Tightening torque: 156.9 ~ 176 N·m N·m (16.0 ~ 18.0 kgf·m, 115.7 ~ 130.2 ft-lbf)

  18. Remove the parking cable by loosening the mounting bolts.

    Tightening torque: 8.8 ~ 13.7 N·m

  19. Loosen the EPB mounting bolts and remove the EPB unit.

    Tightening torque: 8.8 ~ 13.7 N·m

  20. Installation is in the reverse order of removal.
  21. Inspect the rear wheel toe and camber. (Refer to Tires/Wheels - Wheel Alignment)

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.