Shift Cable Repair Procedures

Removal

1. 1
   Remove the nut (B) and clip (C).
2. 2
   Remove the shift cable assembly (A) from the transaxle.

   Tightening torque: 12.7 - 15.7 N·m

   

3. 3
   Remove the floor console. (Refer to Body - "Floor Console")
4. 4
   Disconnect the shift cable (A) from the shift lever.

   

5. 5
   Remove the shift cable assembly (B) by removing the nuts (A).

   Tightening torque: 6.9 ~ 10.8 N·m

   

6. 6
   Remove the rubber plug from the floor and pull out the shift cable assembly.

Installation

1. To install, reverse the removal procedure.

Adjustment

How to Adjust the Shift Cable

1. 1
   Insert the shift cable into the bracket and secure it with a new clip.
2. 2
   Align the hole in the manual control lever with the hole in the transaxle case and secure the position with a pin.
3. 3
   Eliminate the play in the shift cable.
4. 4
   Hold the special bolt firmly with a wrench and tighten the nut (A) to the specified torque.

   Tightening torque: 13 - 16 N·m

   

5. 5
   Remove the bracket holding the manual control lever.
6. 6
   Check the smooth operation of the shift lever by shifting through each position.