Hyundai Genesis DH Quiz
Brake System

Stop Lamp Electronic Module Repair Procedures

In this manual: Brake System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
6steps
~36min
2/5difficulty
Done 0 of 6

Inspection

1. Check Fuses. Connect a test fuse to the switch fuse and relay fuse part to check for normal continuity.
2. Check Connectors by Part. Check each connector for damage, terminal overheating, or incomplete connection. [Engine Room Junction Box]
[Stop Lamp Electronic Module]
[ABS/VDC Control Module]
3. Inspect the Stop Lamp Circuit. Connect the probe to each contact wire and check the signal waveform. [Stop Lamp Switch Input/Output]
[Stop Lamp Electronic Module Input/Output]
[Oscilloscope Waveform Screen]

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the AVN unit. (Refer to Body Electrical System - AVN System) (Refer to Body Electrical System - Premium AVN System)
  3. Remove the glove box. (Refer to Body - Glove Box)
  4. Disconnect the stop lamp electronic module connector (A).
  5. Remove the clip (B), then remove the stop lamp electronic module.
  6. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.