TPMS SENSOR Repair Procedures

REPLACEMENT

1. 1
   Remove the wheel. (Refer to Tires/Wheels — "Tires")
2. 2
   Remove the screw using a Torx screwdriver (A).

   

3. 3
   Remove the sensor body (A) from the valve (B) in the direction of the arrow.

   

4. 4
   Remove the valve using the valve assembly tool.

   1. Cut the rubber at the bottom of the valve with a utility knife.

      

   2. Use the valve installation tool to pull the valve out until it is completely out of the bottom hole.

      

5. 5
   Apply lubricant to the valve surface, then install it through the wheel valve hole.
6. 6
   Apply soapy water or lubricant to the top/bottom of the tire bead.

   

7. 7
   To lower the bead, place the TPMS sensor at the 5 o'clock position on the tire changer.

   

8. 8
   Rotate the rim clockwise, then press the tire toward the 3 o'clock position to lift the lower bead.

   

9. 9
   To raise the beads higher, press the tire at the 3 o'clock position and rotate the rim clockwise.

   

10. 10
    Inflate the tire until the beads seat properly.

    

11. 11
    Adjust the tire pressure to the recommended pressure for the vehicle.
12. 12
    If the TPMS sensor is malfunctioning, perform TPMS sensor registration. Replace the faulty sensors and perform TPMS sensor registration.

ITEM

1. 1
   Install the GDS (Global Diagnostic System) and the GDS TPMS module into the vehicle.
2. 2
   Select the model and perform the sensor registration procedure according to the GDS instructions as follows.