Hyundai Kona Quiz
Brake System

Brake Pedal Repair Procedures

In this manual: Brake System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
8steps
~48min
2/5difficulty
0102030405025.519N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the lower driver airbag panel. (Refer to Body - "Driver Airbag Module")
  3. Disconnect the stop lamp switch connector (A).
  4. Separate the lock pin (A) and the flat head pin (B).
  5. Remove the brake pedal assembly (A) after loosening the mounting bolts and nuts.

    Tightening torque: 16.7–26 N·m

Inspection

  1. Inspect the brake pedal for bending or twisting.
  2. Inspect the brake pedal return spring for damage.
  3. Inspect the stop lamp switch. (Refer to Brake System - "Stop Lamp Switch").

Installation

  1. To install, reverse the removal procedure.

Installation

  1. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.