Hyundai Kona Quiz
Brake System

Master Cylinder Repair Procedures

In this manual: Brake System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
12steps
~72min
3/5difficulty
0102030405022.617N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the air cleaner. (Refer to Engine Mechanical System - "Air Cleaner")
  3. Remove the battery. (Refer to Engine Electrical System - "Battery")
  4. Remove the ECM. (Refer to Engine Control System - "ECM")
  5. Disconnect the brake fluid level sensor connector (A).
  6. Remove the brake fluid from the master cylinder reservoir using a syringe.
  7. Remove the wire harness clip (A).
  8. Loosen the flare nuts and separate the brake tube (A) from the master cylinder.

    Tightening torque: 18.6 – 23 N·m

  9. Remove the master cylinder after loosening the master cylinder mounting nuts.

    Tightening Torque: 9.8–15.9 N·m

  10. Separate the reservoir from the master cylinder after removing the screw (A).

Installation

  1. To install, reverse the removal procedure.
  2. After installation, bleed the brake system. (Refer to Brake System - "Brake Bleeding") (Refer to Brake System - "ABS Bleeding") (Refer to Brake System - "ESP Bleeding")

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.