Dual Clutch Unit Repair Procedures

Removal

1. 1
   Remove the dual clutch transmission from the vehicle. (Refer to Dual Clutch System - "DCT")
2. 2
   Remove the snap ring (A), then remove the spline hub (B).

   

3. 3
   Remove the snap ring (A).

   

4. 4
   Remove the dual clutch assembly (A) using the Special Service Tool (SST) [No.: 09430-C1180].

   

Installation

1. 1
   Install the SST (No.: 09430-2A240) onto the dual clutch assembly support bearing (A).

   

2. 2
   Install the dual clutch assembly (A) using the SST (No.: 09430-2A240). Then install the SST (No.: 09430-2A240) from the clutch housing side.

   

3. 3
   Install the snap ring (A).

   

4. 4
   Install the spline hub (B) and the snap ring (A).

   

5. 5
   Install the dual clutch transmission assembly. (Refer to Dual Clutch System - "DCT")
6. 6
   After installing a new dual clutch assembly, perform the work procedure to reset the wear compensation. (Refer to Clutch Actuator - "Adjustment")
7. 7
   After replacing the dual clutch assembly, perform the clutch touch point learning procedure using GDS.