Hyundai Kona Quiz
Restraints

Front Impact Sensor (FIS) Repair Procedures

In this manual: Restraints
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
7steps
~42min
3/5difficulty
010203040509.87N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Removal

  1. Disconnect the negative battery cable and wait at least three minutes before starting work.
  2. Loosen the mounting bolt and remove the front impact sensor after disconnecting the connector (A).

Installation

  1. Install a new front impact sensor.
  2. Connect the front impact sensor connector.
  3. Install the front impact sensor mounting bolt.

    Tightening torque: 7.8–9.8 N·m

  4. Connect the negative battery cable.
  5. After installing the front impact sensor, check that the system operates correctly:
    • Turn the ignition ON; the SRS indicator should illuminate for about six seconds and then go off.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.