Hyundai Kona Quiz
Restraints

Seat Belt Buckle Switch (BS) Repair Procedures

In this manual: Restraints
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
9steps
~54min
3/5difficulty
Done 0 of 9

Removal

  1. Disconnect the negative battery cable and wait at least three minutes before starting work.
  2. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")
  3. Remove the seat belt buckle switch (A) after loosening the switch mounting bolt.

Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the negative battery cable and wait at least three minutes before starting work.
  3. Install the seat belt buckle switch.
  4. Install the front seat assembly. (Refer to Body - "Front Seat Assembly")
  5. Connect the negative battery cable.
  6. After installing the seat belt buckle switch, check that the system operates properly.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.