Side Impact Sensor (SIS) Repair Procedures

Removal

1. 1
   Disconnect the negative battery cable and wait at least three minutes before starting work.
2. 2
   Remove the front door trim panel. (Refer to Body - "Front Door Trim")
3. 3
   Loosen the mounting bolt and remove the side impact sensor, then disconnect the connector (A).

   

4. 4
   Disconnect the negative battery cable and wait at least three minutes before starting work.
5. 5
   Remove the door scuff plate. (Refer to Body - "Interior Trim")
6. 6
   Remove the center pillar trim. (Refer to Body - "Interior Trim")
7. 7
   Loosen the mounting bolt and remove the side impact sensor, then disconnect the connector (A).

   

Installation

1. 1
   Install the pressure side impact sensor with the screw, then connect the pressure side impact sensor connector.

   Tightening torque: 2.0–2.9 N·m

2. 2
   Install the front door trim panel. (Refer to Body - "Front Door Trim Panel")
3. 3
   Connect the negative battery cable.
4. 4
   After installing the side impact sensor, check that the system operates properly.

   • Turn the ignition ON; the SRS indicator should illuminate for about six seconds and then go off.

1. 1
   Install the side impact sensor with the bolt, then connect the side impact sensor connector.

   Tightening torque: 7.8–9.8 N·m

2. 2
   Install the center pillar trim. (Refer to Body - "Interior Trim")
3. 3
   Install the door scuff plate. (Refer to Body - "Interior Trim")
4. 4
   Connect the negative battery cable.
5. 5
   After installing the side impact sensor, check that the system operates properly.

   • Turn the ignition ON; the SRS indicator should illuminate for about six seconds and then go off.