SRS Control Module (SRSCM) Repair Procedures

Removal

1. 1
   Remove the ignition key from the vehicle.
2. 2
   Disconnect the negative battery cable and wait at least three minutes before starting work.
3. 3
   Remove the floor console. (Refer to Body - "Floor Console Assembly")
4. 4
   Remove the floor air duct (A).

   

5. 5
   Disconnect the SRSCM connectors.

   

6. 6
   Remove the SRSCM (A) after loosening the mounting nuts.

   

Installation

1. 1
   Remove the ignition key from the vehicle.
2. 2
   Disconnect the negative battery cable and wait at least three minutes before starting work.
3. 3
   Install the SRSCM (A) using the SRSCM mounting nuts.

   Tightening torque: 7.8–9.8 N·m

   

4. 4
   Connect the SRSCM wiring harness connectors.
5. 5
   Install the heater ducts and floor console. (Refer to Body - "Floor Console Assembly")
6. 6
   Connect the negative battery cable.
7. 7
   After installing the SRSCM, check that the system operates correctly: Turn the ignition ON; the SRS indicator should illuminate for about six seconds and then go off.

Variant Coding