Hyundai Palisade Quiz
Engine Electrical System

Generator

In this manual: Engine Electrical System
General Information — 10Engine Mechanical System — 56Engine Electrical System — 28Emission Control System — 21Engine Control System/Fuel System — 42Automatic Transmission System (A8LF1) — 33All-Wheel Drive (AWD) System — 16Drive Shaft and Axle — 19Suspension System — 28Steering — 17Restraints — 20Brake System — 39Body (Interior and Exterior) — 142Body Electrical System — 171Heating, Ventilation, and Air Conditioning — 47Advanced Driver Assistance System (ADAS) — 44
12steps
~72min
3/5difficulty
02040608010063.747N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Specifications

Specification

Item Specification
Rated Voltage 13.5 V, 180 A
Operating Speed 1500–18,000 rpm
Voltage Regulator Built-in IC regulator type
Regulated Voltage Default (V) [COM Terminal] 14.09 - 14.91 (-35°C)
13.96 - 15.04 (140°C)
Pin 1

Hyundai Palisade. Specifications

Description and Operation

Description

The AC generator has eight built-in diodes, each of which converts alternating current to direct current. Therefore, direct current appears at the "B" terminal of the alternator. In addition, the charging voltage of this alternator is regulated by the battery voltage sensing system. The alternator is regulated by the battery voltage sensing system. The main components of the alternator are the rotor, stator, rectifier, capacitor, brushes, bearings and poly-V belt pulley. The brush holder contains a built-in electronic voltage regulator.
Hyundai Palisade. Description and operation

1. Brush 2. Drive belt pulley 3. Rotor 4. Stator


Circuit Diagrams

Wiring Diagram

Hyundai Palisade. Schematic diagrams
Hyundai Palisade. Schematic diagrams
  • COM Signal - LIN Communication Control
  • B+ Terminal — Generator output voltage to the battery through the B+ terminal.

Repair Procedures

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  2. Loosen the alternator nut, then disconnect the cable (A) from the "B" terminal of the alternator.
  3. Disconnect the alternator connector (B).
    Hyundai Palisade. Repair procedures
  4. Remove the upper alternator bolt (A). Upper alternator bolt: 49.0–64 N·m
    Hyundai Palisade. Repair procedures
  5. Raise the vehicle.
  6. Remove the engine room cover. (Refer to Engine Mechanical System - "Engine Room Cover")
  7. Remove the drive belt. (Refer to Engine Mechanical System - "Drive Belt")
  8. Disconnect the compressor ECV connector, then loosen the mounting bolts and widen the gap between the compressor (A) and the engine to remove the alternator.
    Hyundai Palisade. Repair procedures
  9. Remove the lower alternator bolt (A). Lower alternator bolt: 49.0–64 N·m
    Hyundai Palisade. Repair procedures
  10. Remove the alternator (A).
    Hyundai Palisade. Repair procedures

Installation

  1. Install in the reverse order of removal.
  2. Install the drive belt. (Refer to Engine Mechanical System - "Drive Belt")

Test yourself

A quick Hyundai Palisade quiz: every answer comes with an explanation and a link to the manual page.