Hyundai Palisade Quiz
Heating, Ventilation, and Air Conditioning

Receiver-Drier

In this manual: Heating, Ventilation, and Air Conditioning
General Information — 10Engine Mechanical System — 56Engine Electrical System — 28Emission Control System — 21Engine Control System/Fuel System — 42Automatic Transmission System (A8LF1) — 33All-Wheel Drive (AWD) System — 16Drive Shaft and Axle — 19Suspension System — 28Steering — 17Restraints — 20Brake System — 39Body (Interior and Exterior) — 142Body Electrical System — 171Heating, Ventilation, and Air Conditioning — 47Advanced Driver Assistance System (ADAS) — 44
4steps
~24min
2/5difficulty
010203040503.22N·mlb·ft
Tightening torque found on this page
Done 0 of 4

Repair Procedures

Replacement

  1. Remove the condenser. (Refer to Air Conditioning System - "Condenser")
  2. Remove the cap (B) at the bottom of the condenser using an L-shaped wrench (A).

    Tightening torque: 2.7–3.2 N·m

    Hyundai Palisade. Repair procedures
  3. Remove the receiver-drier (A) from the condenser using long-nose pliers. Check that the receiver-drier is not crumbled and that the lower cap filter is not clogged.
    Hyundai Palisade. Repair procedures
  4. Install in the reverse order of removal.
    Hyundai Palisade. Repair procedures
    • Always replace the receiver-drier and the lower cover at the same time.
    • Replace the O-rings with new ones at each fitting and apply a thin coat of refrigerant oil to them before installation. Be sure to use O-rings suitable for R-134a or R-1234yf to prevent leakage.
    • Be careful not to damage the radiator and condenser fins when installing the condenser.
    • Charge the system and check that it operates properly.

Test yourself

A quick Hyundai Palisade quiz: every answer comes with an explanation and a link to the manual page.