Rear Sunshade Reset

The rear sunshade may need to be reset if the following conditions occur:

- The battery is discharged or disconnected, or the related fuse has been replaced or removed
- The rear sunshade does not operate normally

To reset the rear sunshade, perform the following steps:

1. Start the engine.

2. Push the rear sunshade CLOSE button. The rear sunshade will close fully.

3. Push and hold the rear sunshade CLOSE button for about 10 seconds.

The rear sunshade will move slightly.

Do not release the CLOSE button until the operation is complete.

If you release the CLOSE button, try again from step 2.

4. Within 3 seconds, push and hold the CLOSE button until the rear sunshade operates as follows:

Open → Close

Do not release the CLOSE button until the operation is complete.

If you release the CLOSE button during operation, try again from step 2.

5. Release the CLOSE button after the entire operation is complete.

The rear sunshade system has been reset.