Rear Center Seat Belt

To fasten the seat belt:

1. Pull the latch (A) out of the hole in the belt system cover.

2. Insert the tongue (A) into the buckle (A') until you hear a click, indicating the latch is locked. Make sure the belt is not twisted.

3. Remove the tab (B) from the storage (C).

4. Pull the tab (B) and insert it into the buckle (B') until it stops. You will hear a click, indicating the latch is locked. Make sure the belt is not twisted.

The rear center seat belt must be attached to the buckle marked "CENTER".

Information

If you cannot pull out enough belt by pulling gently on it, pull the seat belt firmly, then release it. You can then extend it without any problems.

To unfasten the seat belt:

1. Press the buckle release button (B') and remove the tongue (B) from the buckle.

2. Insert the projection (B) into the storage (C).

3. To retract the rear center seat belt, insert the tongue into the hole provided for this purpose (A'). Pull the seat belt retractor so that the belt retracts automatically.

4. Insert the tongue (A) into the hole in the belt system cover.

Lap Seat Belt (rear center 2-point seat belt, if equipped)

To fasten the rear center seat belt:

Insert the metal tongue into the buckle. A click is heard when the tongue locks into the buckle. Make sure the seat belt is securely locked and not twisted.

The length must be adjusted manually so that the seat belt fits snugly against the hips. Fasten the seat belt and pull the free end to tighten the belt.

The seat belt must be positioned as low as possible on the hips, not on the waist. If the seat belt is too high, the risk of injury in an accident increases.

To unfasten the rear center seat belt:

Press the buckle release button (1) and remove the metal tongue from the buckle.

Storing the Rear Belt

When not in use, the rear seat belt buckles can be stored in the pocket located between the rear seatback and the seat cushion.