control cable

Components and Component Location

COMPONENTS

Repair Procedures

DEPOSIT

1. 1
   Move the shift lever to 4th gear.
2. 2
   Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")
3. 3
   Disconnect the battery and battery tray. (Refer to Engine Electrical System - "Battery".)
4. 4
   Disconnect the shift cable (A) and select cable (B) from the cable bracket (C) after removing the snap rings (D - 2 pcs).

   

5. 5
   Remove the shift knob and the shift lever boot (A) by turning counterclockwise.

   

6. 6
   Remove the floor console assembly. (Refer to Body group - "Floor Console")
7. 7
   Disconnect the shift cable (B) and select cable (C) after removing the snap ring (A).

   

8. 8
   Remove the retainer (A) after removing the nuts (B - 2 pcs).

   

REMEDY

1. 1
   Install the retainer (A) and tighten the nuts (B - 2 pcs).

   Tightening torque: 8.8 - 13.7 N·m

   

2. 2
   Install the shift cable (B) and select cable (C), then attach the pin (A).

   

3. 3
   Move the lock device (B) in the "F" direction by pulling the bracket (A) in the "P" direction.

   

4. 4
   Install the shift cable (A) and select cable (B), then attach the snap rings (C - 2 pcs).

   

5. 5
   Tighten the bracket (A) in the "P" direction after fixing the lever (B) in the "F" direction.

   

6. 6
   Remove the 4th fixed pin from the shift lever (A).

   

7. 7
   Install the floor console assembly (Refer to Body - "Floor Console").
8. 8
   Install the shift lever knob and boot (A).

   

9. 9
   Install the battery and battery tray. (Refer to Engine Electrical System - "Battery".)
10. 10
    Install the air cleaner and air duct. (See Engine Mechanical System - "Air Filter").