FRONT WIPER MOTOR

Components and Component Location

COMPONENT LOCATION

Repair Procedures

DEPOSIT

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   If necessary, loosen the wiper blade lock by pulling it and remove the wiper blade from the inner radius (A) of the wiper arm.

   

3. 3
   Remove the upper hood cover. (Refer to Body group - "Upper Cowl Cover")
4. 4
   Remove the wiper motor and linkage (A) after disconnecting the wiper motor connector (B).

   

5. 5
   While holding the wiper motor crank arm, remove the upper link (A).

   

   

6. 6
   Remove the lower link (A) from the wiper motor crank arm.

   

7. 7
   Remove the crank arm (B) after loosening the nut (A).

   

8. 8
   Loosen the bolts, then remove the wiper motor (A).

   

REMEDY

1. 1
   Install the wiper motor.
2. 2
   Install the crank arm.

   Tightening torque: 13.0~13.5 N·m

3. 3
   Install the lower and upper links to the wiper motor crank arm.
4. 4
   Install the wiper motor and its wiring, then connect its connector.

   Tightening torque: 6.9~10.8 N·m

5. 5
   Install the windshield garnish molding.
6. 6
   Install the windshield wiper arm and blade.

   Tightening torque: 22.5~26 N·m

7. 7
   Position the wiper arm and blade as shown in the automatic stop position (blade).

   

Inspection

1. 1
   Disconnect the wiper motor connector.

   

   NO	Description
   1	-
   2	ALL2
   3	PARK
   4	High speed
   5	MASS
   6	Low speed

2. 2
   Disconnect the positive (+) battery cable from terminal 2 and the negative (-) cable from terminal 5 of the battery.

   

   

Verification (with GDS)

1. 1
   In the body electrical system, a fault can be quickly diagnosed using the Global Diagnostic System (GDS). The GDS provides the following information.

   1. Self-diagnosis: checks for malfunctions and the number of codes (DTC)
   2. Current data: checking the input/output status of the system
   3. Operation check: checks the operating conditions of the system
   4. Additional function: controls other functions, including additional system setup and zero point adjustment
2. 2
   Select "Vehicle Model" and "Body Control Module (BCM)" to check the vehicle with the tester.
3. 3
   Select the "Current Data" menu to check the current status of inputs and outputs.