Hyundai Tucson Quiz
Body Work (Interior and Exterior)

Front Door Glass

In this manual: Body Work (Interior and Exterior)
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
6steps
~36min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Components and Component Location

COMPONENT LOCATION

1. Front Door Window Glass

Repair Procedures

REPLACEMENT

  1. Remove the front door trim. (Refer to Front Door - "Front Door Trim")
  2. Remove the front door belt inner seal (A).
  3. Separate the installation plug hole (A) from the front door module.
  4. Lower the window by pressing the window switch until the glass mounting bolt is aligned with the hole in the cap.
  5. Loosen the window mounting bolts, adjust the window gap (A) by moving it on each side, then tighten the bolts.

    Tightening torque: 7.8 – 11.8 N·m

  6. To install, perform the removal procedure in reverse order.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.