Hyundai Tucson LM Quiz
Body (Interior and Exterior)

Body Side Moulding Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
20steps
~120min
4/5difficulty
Done 0 of 20

Replacement

Roof Rack Replacement
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Wear gloves to protect your hands.
  • Be careful not to scratch the body surface.
  1. Using a screwdriver or a pry tool, remove the roof rack cover (A).
  2. Loosen the retaining nuts and remove the roof rack (B).
  3. Install in the reverse order of removal.
Roof Molding Replacement
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Wear gloves to protect your hands.
  • Be careful not to scratch the body surface.
  1. Remove the roof rack.
  2. Using a screwdriver or remover, remove the roof moulding (A).
  3. Install in the reverse order of removal.
    • Replace any damaged clips.
Rear Door Garnish Replacement
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Wear gloves to protect your hands.
  • Be careful not to scratch the body surface.
  1. Remove the rear door trim panel. (Refer to Exterior - "Rear Door")
  2. Disconnect the connector (A).
  3. Loosen the retaining nuts and remove the rear door garnish (A).
  4. Install in the reverse order of removal.
    • Replace any damaged clips.
Rear Spoiler Replacement
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Wear gloves to protect your hands.
  • Be careful not to scratch the body surface.
  1. Remove the rear door trim panel. (Refer to Exterior - "Rear Door")
  2. Loosen the mounting nuts and remove the rear spoiler (A).
  3. Disconnect the connector (A) and the washer nozzle (B).
  4. Install in the reverse order of removal.
    • Replace any damaged clips.
Door Side Garnish Replacement
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Wear gloves to protect your hands.
  • Be careful not to scratch the body surface.
  1. Using a screwdriver or a pry tool, remove the front door garnish (A).
  2. Using a screwdriver or a pry tool, remove the rear door garnish (B).
  3. Install in the reverse order of removal.
    • Replace any damaged clips.
Side Sill Replacement
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Wear gloves to protect your hands.
  • Be careful not to scratch the body surface.
  1. Loosen the retaining screws.
  2. Using a screwdriver or a pry tool, remove the side sill garnish (A).
  3. Install in the reverse order of removal.
    • Replace any damaged clips.

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.