Rear Liftgate Repair Procedures

Replacement

Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage. Wear gloves to protect your hands. Make sure the liftgate locks/unlocks and opens/closes properly.

1. 1
   Remove the upper garnish (B).
2. 2
   After loosening the fastening screws, remove the liftgate garnish (C) and the side trim (A).
3. 3
   Install in the reverse order of removal.

   Replace any damaged clips. Make sure it opens securely.

   

4. 4
   Remove the liftgate garnish.
5. 5
   After loosening the fastening bolts, remove the latch assembly (A).

   Tightening torque: 6.9 ~ 10.8 N·m

   

6. 6
   Install in the reverse order of removal.

   Make sure the rear liftgate opens properly.

Be careful not to let the rear liftgate close when removing the lift support.

1. 1
   Using a screwdriver (A), gently lift the socket retainer (B) at both ends of the lift support (D), then remove the lift support from the bracket (C).

   

2. 2
   Insert the lift support socket into the bracket for installation.

   Make sure the liftgate locks/unlocks and opens/closes properly.

Do not apply sealant to the body.

1. 1
   Remove the liftgate weatherstrip (A).

   

2. 2
   Install in the reverse order of removal.

   Install the seal, aligning it with the gallop line (B).

Adjustment

1. 1
   Make sure the door and body edges are parallel.
2. 2
   Loosen the rear door hinge mounting bolt (A), then adjust the rear door by moving it up or down, right or left.
3. 3
   Adjust the striker (D) by moving it up or down, right or left.
4. 4
   Make sure the liftgate operates properly and closes securely.