Hyundai Tucson LM Quiz
Automatic Transmission

Line Pressure Control Solenoid Valve Repair Procedures

In this manual: Automatic Transmission
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
4steps
~24min
2/5difficulty
Done 0 of 4

Inspection

  1. Turn the ignition off.
  2. Disconnect the solenoid valve sensor connector.
  3. Measure the resistance between the sensor signal terminal and the sensor ground terminal.
  4. Make sure the resistance is within specification.

Removal
Replacement of the on/off solenoid valves (SS-A, SS-B) does not require hydraulic pressure adjustment; however, hydraulic pressure must be adjusted after replacing the VFS solenoid valve. When replacing the VFS solenoid valve, also replace the valve body assembly. (Refer to Hydraulic System - Valve Body)

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.