Hyundai Tucson LM Quiz
Automatic Transmission

Input Speed Sensor Repair Procedures

In this manual: Automatic Transmission
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
3steps
~18min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 3

Inspection

  1. Check the input and output speed sensor signal waveform using GDS.

    Specification: Refer to "Signal Waveform" section.

Removal

  1. Remove the valve body assembly. (Refer to Hydraulic System - "Valve Body")
  2. Disconnect the input and output speed sensor connector (A) from the main wiring harness.
  3. Remove the input and output speed sensor (B) by unscrewing the bolts (2EA).

    Tightening torque: 9.8 ~ 11.8 N·m

Installation

  1. Install in the reverse order of removal.
    • Add coolant. (Refer to Engine Mechanical System - "Coolant")
    • Add Automatic Transmission Fluid (ATF).

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.