Oil Pressure Measurement

• Remove: Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Oil Passage Plug [A]

• Attach the adapter [A] and gauge [B] to the plug hole.

Special Tools - Oil Pressure Gauge, 10 kgf/cm²: 57001-164 Oil Pressure Gauge Adapter, PT3/8: 57001 -1233

• Start the engine and warm up the engine.
• Run the engine at the specified speed, and read the oil pressure gauge.

Oil Pressure

Standard: About 196 kPa (2.00 kgf/cm², 28 psi) at 4 000 r/min (rpm), Oil Temperature 50В°C (122В°F)

If the reading is much lower than the standard, check the oil pump, relief valve, and/or crankshaft bearing insert wear immediately.

If the reading is much higher than the standard, check the oil passages for clogging.

• Stop the engine.
• Remove the oil pressure gauge and adapter.

WARNING

Hot oil can cause severe burns. Beware of hot engine oil that will drain through the oil passage when the gauge adapter is removed.

• Apply a non-permanent locking agent to the oil passage plug, and tighten it.

Torque - Oil Passage Plug (Taper): 20 NВ·m (2.0 kgfВ·m, 15 ftВ·lb)