Emergency Front Belt Fixing Device (EFD) Repair Procedures

Removal

1. 1
   Disconnect the negative battery cable and wait at least thirty seconds before starting work.
2. 2
   The emergency fastening device (EFD) (A) can be removed by pressing the locking pin (B) in the direction indicated by the arrow.

   

3. 3
   Remove the door scuff trim. (Refer to Body - "Door Scuff Trim")
4. 4
   Remove the center pillar trim. (Refer to Body - "Center Pillar Garnish")
5. 5
   Disconnect the EFD connector (A).

   

6. 6
   Loosen the emergency locking device mounting bolt (B) and remove the emergency locking device.

Installation

1. 1
   Remove the ignition key from the vehicle.
2. 2
   Disconnect the negative (-) battery cable and wait at least thirty seconds.
3. 3
   Install the emergency fastening device with the bolt.

   Tightening torque: 39.2 ~ 54 N·m

4. 4
   Connect the emergency fastening device connector.
5. 5
   Install the center pillar trim. (Refer to Body - "Center Pillar Garnish")
6. 6
   Install the door scuff trim. (Refer to Body - "Door Scuff Trim")
7. 7
   Insert the seat belt into the emergency locking retractor (A).

   

   Make sure the stopper pin is inserted correctly.

8. 8
   Connect the negative battery cable.
9. 9
   After installing the emergency fastening device, check that the system operates correctly:

   • Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.