Seat Belt Pretensioner (BPT) Repair Procedures

Removal

1. 1
   Disconnect the negative battery cable and wait at least thirty seconds before starting work.
2. 2
   The emergency fastening device (EFD) (A) can be removed by pressing the locking pin (B) in the direction indicated by the arrow.

   

3. 3
   Remove the door scuff trim. (Refer to Body - "Door Scuff Trim")
4. 4
   Remove the center pillar trim. (Refer to Body - "Center Pillar Trim")
5. 5
   Remove the upper anchor bolt.
6. 6
   Disconnect the seat belt pretensioner connector (C).

   

7. 7
   Loosen the seat belt pretensioner mounting bolts (A, B) and remove the seat belt pretensioner.

Installation

1. 1
   Remove the ignition key from the vehicle.
2. 2
   Disconnect the negative battery cable and wait at least thirty seconds.
3. 3
   Install the seat belt pretensioner using the bolts (A, B).

   Tightening torque Bolt B: 39.2 ~ 54 N·m

   

4. 4
   Connect the seat belt pretensioner (BPT) connector (C).
5. 5
   Install the upper anchor bolts.

   Tightening torque: 39.2 ~ 54 N·m

6. 6
   Install the center pillar trim. (Refer to Body - "Center Pillar Trim")
7. 7
   Install the door scuff trim. (Refer to Body - "Door Scuff Trim")
8. 8
   Insert the seat belt into the anchor tensioner (A).

   

   Make sure the stopper pin is inserted correctly.

9. 9
   Connect the negative battery cable.
10. 10
    After installing the seat belt pretensioner, check the system operation:

    • Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.