Engine Mechanical System

Rear Oil Seal Repair procedures

8steps
~58min
4/5difficulty
2special tools
Done 0 of 8

Replacement

  1. Shut off the high voltage circuit.

    (Refer to Engine Mechanical System - “High Voltage Shut off Procedure”)

  2. Remove the dual clutch transmission.

    (Refer to Dual Clutch Transmission (DCT) - "Dual Clutch Transmission Assembly")

  3. Remove the engine clutch disk and clutch cover.

    (Refer to Engine Clutch System - "Clutch Cover and Disk")

  4. Remove the flywheel.

    (Refer to Cylinder Block - "Flywheel")

  5. Remove the rear oil seal (A).

  6. Apply engine oil on new oil seal lip.

  7. Using the SST (09231-H1100, 09231-G2200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

  8. Install in the reverse order of removal.