Hybrid Motor System

Reservoir Repair procedures

11steps
~66min
3/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 11

Removal

  1. Remove the under cover.

    (Refer to Engine Mechanical System - "Engine Room Under Cover")

  2. Drain the coolant of hybrid motor cooling system.

    (Refer to Hybrid Motor Cooling System - "Coolant")

  3. Separate the hose (A) and then remove the reservoir (B) by loosening the bolts.

    Tightening torque : 7.8 - 11,8 N·m

Installation

  1. Install in the reverse order of removal.

Inspection

Inverter Reservoir Cap Testing

  1. Remove the inverter reservoir cap, wet its seal with coolant, and then install it on a pressure tester.

  2. Apply a pressure of 93.16 - 122.58kPa (0.95 - 1.25kgf/cm², 13.51 - 17.78psi).

  3. Check for a drop in pressure.

  4. If the pressure drops, replace the cap.

Radiator Leakage Test

  1. Wait until engine is cool, then carefully remove the inverter reservoir cap and fill the reservoir with coolant, then install it on the pressure tester.

  2. Apply a pressure tester to the reservoir and apply a pressure of 93.16 - 122.58kPa (0.95 - 1.25kgf/cm², 13.51 - 17.78psi).

  3. Inspect for inverter coolant leaks and a drop in pressure.

  4. Remove the tester and reinstall the inverter reservoir cap.