Hybrid Motor System

Radiator Repair procedures

19steps
~114min
4/5difficulty
0102030405013.710N·mlb·ft
Tightening torque found on this page
Done 0 of 19

Removal

  1. Disconnect the negative (-) cable of the 12V battery.

  2. Remove the under cover.

    (Refer to Engine Mechanical System - "Engine Room Under Cover")

  3. Drain the coolant of hybrid motor cooling system.

    (Refer to Hybrid Motor Cooling System - "Coolant")

  4. Remove the front bumper.

    (Refer to Body - "Front Bumper")

  5. Remove the active air flap.

    (Refer to Engine Mechanical System - "Active Air Flap")

  6. Remove the condenser.

    (Refer to Heating, Ventilation and Air Conditioning - "Condenser")

  7. Remove the upper air guard (A).

  8. Separate the radiator upper hose (A).

  9. Loosen the nut (A).

    Tightening torque : 8.8 - 13,7 N·m

  10. Separate the radiator lower hose (A).

  11. Remove the radiator (A) by loosening the nuts.

    Tightening torque : 7.8 - 11,8 N·m

Installation

  1. Install in the reverse order of removal.

Inspection

Pressure Cap Testing

  1. Install the pressure cap and pressure tester on a SST (0K253-G5100).

  2. Apply a pressure of 79.4 - 122.58 kPa (0.95 - 1.25 kgf/cm², 11.5 - 17.78 psi).

  3. Check for a drop in pressure.

  4. If the pressure drops, replace the pressure cap.

Radiator motor Test

  1. Wait until motor is cool, then carefully remove the pressure cap and fill the reservoir tank with coolant, then install it on the pressure tester.

  2. Apply a pressure tester to the radiator and apply a pressure of 93.16 - 122.58 kPa (0.95 - 1.25 kgf/cm², 13.51 - 17.78 psi).

  3. Inspect for coolant leaks and a drop in pressure.

  4. Remove the tester and reinstall the pressure cap.