Engine Mechanical System

Thermostat Troubleshooting

~2min read

Troubleshooting

Symptoms Possible Causes Remedy
Coolant leakage
  • From the thermostat gasket

Check the mounting bolts
  • Check the torque of the mounting bolts

  • Retighten the bolts and check leakage again.

Check the gasket for damage
  • Check gasket or seal for damage

  • Replace gaskets and reuse the thermostat.

Cooled excessively
  • Low heater performance (cool air blows-out)

  • Thermogauge indicates 'LOW'

Visually check after removing the radiator cap.
  • Insufficient coolant or leakage.

  • After refilling coolant, recheck.

Check KDS/GDS and start engine
  • Check DTCs

  • Check the fan motor performance as temperature varies.

  • Check connection of the fan clutch or the fan motor.

※ If the fan clutch is always connected, there will be a noise at idle.
  • Check the engine coolant sensor, wiring and connectors.

  • Check the fan motor, the relay and the connector.

  • Replace the components.

Remove the thermostat and inspect
  • Check for dust or chips in the thermostat valve.

  • Check adherence of the thermostat.

  • Clean the thermostat valve and reuse the thermostat.

  • Replace the thermostat, if it doesn't work properly.

Heated excessively
  • Engine overheated

  • Thermogauge indicates 'HI'

Visually check after removing the radiator cap.
  • Insufficient coolant or leakage.

    ※ Be careful when removing the radiator cap of the overheated vehicle.

  • Check air in cooling system.

  • After refilling coolant, recheck.

  • Check the cylinder head gaskets for damage and the tightening torque of the mounting bolts.

Check KDS/GDS and start engine
  • Check DTCs

  • Check the fan motor performance as temperature varies.

  • Check if the fan clutch slips.

  • Check the water pump adherence or impeller damaged.

  • Check the engine coolant sensor, wiring and connectors.

  • Check the fan motor, the relay and the connector.

  • Replace the fan clutch, if it doesn't work properly.

  • Replace the water pump, if it doesn't work properly.

Immerse the thermostat in boiling water and inspect.
  • After removing the thermostat, check it works properly.

※ Check that the thermostat opens at the valve opening temperature.
  • Replace the thermostat, if it doesn't work properly.