Engine Mechanical System
Troubleshooting
In this manual: Engine Mechanical System
~2min read
Engine Overheat Troubleshooting
| Inspection | Remedy | |
| Visual inspection | Inspect for shortage of coolant in reservoir tank . | Reinspect after replenishing coolant. |
| Inspect for coolant pollution after removing radiator cap. |
Reinspect after replacing coolant. | |
| Inspect for leakage and loose coolant hoses (radiator hose, heater hose, oil cooler hose, etc.). | Reinspect for leakage after reinstalling hoses and clamps. | |
| Inspect for leakage on water inlet fitting mounting part. | Reinspect for leakage after replacing O-ring. | |
| Reinspect for leakage after tightening to the specified torque. | ||
| Inspect drive belt (for normal operation of water pump). | Adjust drive belt tension or replace. | |
| Inspect for leakage on water pump gasket mounting part. | Reinspect for leakage after replacing gasket. | |
| Reinspect for leakage after tightening to the specified torque. | ||
| Inspect for loose coolant temperature sensor, cooling fan connector and pin. | Reinstall loose connector. | |
| Replace relevant part if connector pin is damaged. | ||
| Inspect operation status of cooling fan. - Check operation status by switching ON/OFF the heater control A/C. |
Check mounting status of ground cable. | |
| Diagnostic device | Inspect self-diagnostic code using KDS/GDS. | Check coolant temperature sensor, wiring, connector, etc. |
| Unit inspection | Inspect water pump impeller. | Replace water pump. |
| Inspect for foreign materials and status of thermostat valve. | Inspect unit after removing foreign materials. | |
| Inspect for stuck thermostat valve. - Immerse thermostat in water heated to over 95 °C, then heat for at least 3 minutes to check valve lift. |
Check valve lift. - Replace thermostat if valve lift is below specification or valve is stuck. |
|
Was this page helpful?