Kia Optima Hybrid Owner's Manual Quiz
Engine Control System/Fuel System

Crankshaft Position Sensor (CKPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 4Engine Mechanical System — 50Engine Electrical System — 20Emission Control System — 30Engine Control System/Fuel System — 84Automatic Transmission — 98Drive Shaft and Axle — 15Suspension System — 36Steering — 12Restraints — 50Brake System — 38Body (Interior and Exterior) — 54Body Electrical System — 233Heating, Ventilation, and Air Conditioning — 57
4steps
~24min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 4

Inspection

  1. Check the CMPS and CKPS signal waveforms using the GDS.

    Specification: Refer to Waveform.

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  2. Disconnect the crankshaft position sensor connector (A).
  3. Remove the protector (A).
  4. Remove the mounting bolt (A) and remove the crankshaft position sensor.

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. In this case, inspect it before use.
  • Apply engine oil to the O-ring.
  • Insert the sensor into the mounting hole, being careful not to damage it during installation.
  1. Install in the reverse order of removal. Crankshaft position sensor bolt: 9.8 ~ 11.8 N·m Crankshaft position sensor protector bolt (M6): 9.8 ~ 11.8 N·m

Test yourself

A quick Kia Optima Hybrid Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.