Kia Optima Hybrid Owner's Manual Quiz
Engine Control System/Fuel System

Manifold Absolute Pressure (MAP) Sensor Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 4Engine Mechanical System — 50Engine Electrical System — 20Emission Control System — 30Engine Control System/Fuel System — 84Automatic Transmission — 98Drive Shaft and Axle — 15Suspension System — 36Steering — 12Restraints — 50Brake System — 38Body (Interior and Exterior) — 54Body Electrical System — 233Heating, Ventilation, and Air Conditioning — 57
5steps
~30min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the MAP sensor output voltage at idle and with the ignition ON.
    Test Conditions Output voltage (V)
    IGNITION ON 3,9 ~ 4,1
    Idle 0,8 ~ 1,6

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  2. Disconnect the MAP sensor connector (A).
  3. Remove the mounting bolt (B) and remove the sensor from the expansion tank.

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. In this case, inspect it before use.
  • Insert the sensor into the mounting hole, being careful not to damage it during installation.
  1. Install in the reverse order of removal. MAP sensor mounting bolt: 9.8 ~ 11.8 N·m

Test yourself

A quick Kia Optima Hybrid Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.