Kia Sorento XM Owner's Manual.

Replacing an Inside Panel Fuse

~2min read
1. Turn the ignition switch and all other switches off.

1. Turn the ignition switch and all other switches off.

2. Open the fuse panel cover.

3. Pull the suspected fuse straight out. Use the removal tool provided on the

3. Remove the suspected fuse. Use the removal tool provided on the engine compartment fuse panel cover.

4. Inspect the removed fuse; replace it if it is blown.

Spare fuses are located in the engine compartment fuse panel.

5. Insert a new fuse of the same rating and make sure it is fully seated in the clips.

If it does not seat securely, contact an authorized Kia dealer.

If you do not have a spare, use a fuse of the same rating from a circuit that you may not need to operate the vehicle, such as the power outlet fuse.

If the headlights or other electrical components do not work and the fuses are good, check the fuse panel in the engine compartment. If a fuse is blown, it must be replaced.

Fuse Switch

Always, put the fuse switch at the ON position.

Always keep the fuse switch in the ON position.

If you move the switch to the OFF position, some items such as the audio and digital clock must be reset, and the transmitter (or smart key) may not operate properly.

CAUTION

Always set the fuse switch to the ON position while driving the vehicle.

Replacing an Engine Compartment Fuse

1. Turn the ignition switch and all other switches off.

1. Turn the ignition switch and all other switches off.

2. Remove the fuse panel cover by pressing the tab and pulling the cover upward.

3. Inspect the removed fuse; replace it if it is blown. To remove or insert a fuse, use the fuse puller in the fuse block in the engine compartment.

4. Insert a new fuse of the same rating and make sure it is firmly seated in the clips. If it does not seat securely, contact an authorized Kia dealer.

CAUTION

After inspecting the engine compartment fuse panel, securely reinstall the fuse panel cover. Otherwise, electrical malfunctions may occur due to water contact.

Multi Fuse

If the multi fuse is blown, it must be removed as follows:

If the multi fuse is blown, remove it as follows:

1. Turn off the engine.

2. Disconnect the negative battery cable.

3. Remove the nuts shown in the illustration above.

4. Replace the fuse with a new one of the same rating.

5. Reinstall in the reverse order of removal.

✽ NOTICE

If the multi-fuse has blown, contact an authorized Kia dealer.

Test yourself

A quick Kia Sorento Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.