Kia Cee'd Quiz
Engine Mechanical System

Engine Mount Repair Procedures

In this manual: Engine Mechanical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
13steps
~78min
3/5difficulty
04080120160200127.594N·mlb·ft
Tightening torque found on this page
Done 0 of 13

Removal and Installation

[Roll Rod Mount]
  1. Roll rod bracket mounting bolts and roll rod bracket (A). Tightening torque: Nut (B): 107.9 ~ 128 N·m Bolt (C): 49.0 ~ 64 N·m
  2. Remove the roll rod bracket (A).

    Tightening torque: 49.0 ~ 69 N·m

  3. Install in the reverse order of removal.
  4. Place a jack against the edge of the upper oil pan to support the engine.
  5. Disconnect the ground cable (A) and remove the engine mount bracket (B). Tightening torque: Ground cable bolt: 10.8 ~ 13.7 N·m Nut (C): 88.3 ~ 108 N·m Bolt (D) and nut (E): 58.8 ~ 74 N·m
  6. Install in the reverse order of removal.
  7. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")
  8. Remove the under cover.
  9. Install the jack to the edge of the transaxle.
  10. Remove the cover (A).
  11. Remove the bolt (A) from the transaxle support bracket.

    Tightening torque: 88.3 ~ 108 N·m

  12. Remove the transaxle mounting bracket (A).

    Tightening torque: 63.7 ~ 83 N·m

    Manual transaxle
    Automatic Transmission
  13. Install in the reverse order of removal.
[Engine Mount Bracket] [Transaxle Mount]

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.