TPMS Receiver Repair Procedures

Replacement

1. 1
   Disconnect the negative (-) battery cable.
2. 2
   Remove the main protector assembly. (Refer to Body (Interior and Exterior) - "Main Protector Assembly")
3. 3
   Connector (A) After removing the new receiver (B), it must be replaced.

   

4. 4
   Install in the reverse order of removal.
5. 5
   Reconnect the battery and turn the ignition on.
6. 6
   After replacing the receiver, check using the Generic Diagnostic Scanner (GDS).

   

   

   

[Wheel Sensor ID Registration Initialization (Wireless)] [Wheel Sensor ID Registration (Wireless) 1] [Wheel Sensor ID Registration (Wireless) 2]

Diagnostic Procedure Using the Scan Tool

As a guide to diagnostic procedures using the diagnostic device, the main contents are as follows:

1. 1
   Connect the 16-pin diagnostic connector located in the lower part of the driver side trim panel to the scan tool, then turn on the scan tool after turning the ignition key ON.
2. 2
   On the GDS vehicle selection screen, select "Vehicle Model" and "TPMS," then select OK.

   

   

   

[Vehicle name input initialization] [Vehicle name spelling 1] [Vehicle name spelling 2][Vehicle name spelling 3]

[VIN Input Initialization]

[VIN spelling 1]

[VIN spelling 2]

[VIN spelling 3]