Heating, Ventilation, and Air Conditioning
Temperature Control Actuator
In this manual: Heating, Ventilation, and Air Conditioning
9steps
~54min
2/5difficulty
Done 0 of 9
Components and Component Location
Component Location

| 1. Temperature Control Actuator |
Description and Operation
Description
- The heater unit includes the mode control actuator and the temperature control actuator.
- The temperature control actuator is located on the heater unit. It controls the temperature as follows. A signal from the control unit adjusts the position of the temperature door through the operating temperature switch, and the temperature is then controlled by the ratio of hot/cold air determined by the position of the temperature door.
Repair Procedures
Inspection
- Ignition switch OFF
- Disconnect the temperature control actuator connector.
- Check that the temperature control actuator moves to the hot position when 12 V is applied to terminal 3 and terminal 4 is grounded. Make sure the temperature control actuator operates to the cool position when connections are reversed.

1. -
2. -
3. Cold Position
4. Hot Position5. Sensor (+5V)
6. Feedback Signal
7. Sensor Ground - Check the voltage between terminals 6 and 7 (actuator).
Door Position Voltage (5-6) Fault Detection Max. Cool 0.3 ± 0.15 V Low voltage: 0.1 V or less
High voltage: 4.9 V or moreMax. Heat 4.7 ± 0.15 V
Replacement
- Disconnect the negative (-) battery terminal.
- Disconnect the connector (A), then remove the temperature control actuator (B) after loosening the mounting screws.

- Install in the reverse order of removal.
Test yourself
A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?