Electromagnetic Compatibility

Your Mazda has been tested and certified to comply with UN ECE Regulation No. 10 regarding electromagnetic compatibility*1. Radio-frequency devices (e.g. mobile phones, amateur transceivers, etc.) may be installed in your vehicle only if they meet the parameters given in the table below.

*1 ECE is the abbreviation for Economic Commission for Europe (UNECE or ECE).

Each vehicle user is responsible for using electronic devices that comply with applicable local regulations. All equipment should be installed by suitably trained specialists.

CAUTION

• Do not install relays, microphones, speakers or any other components within the operating range of the airbag system.
• Do not secure the antenna cable to the vehicle's electrical wiring, fuel lines or brake lines. Where possible, avoid routing the antenna cable parallel to wiring harnesses.
• Maintain a distance of at least 100 mm between the antenna cable and power cables, all electrical modules and airbags.
• Do not use the cigarette lighter socket or an auxiliary power outlet as a power source for radio transceivers.

Antenna locations:

1. 1
   front right part of roof
2. 2
   front left part of roof
3. 3
   centre part of roof
4. 4
   both sides of tailgate (hatchback)

   

*1 Bluetooth only

CAUTION

After installing radio transmitters, check that they do not interfere with the operation of other electronic vehicle equipment modules, both during transmission and in standby.

Check all electrical equipment:

• with ignition switch in ON position

• with engine running

• during a road test at various speeds.