Mazda 6 Quiz
Body electrical system

Front fog light aiming

In this manual: Body electrical system
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read

1. Adjust the tire air pressure to the specification.

2. Position the unloaded vehicle on a flat, level surface.

3. Seat one person in the drivers seat.

4. Position the vehicle 3 m {10 ft}

in front of a white screen.


5. While adjusting one fog light, mask the other.

6. Start the engine to charge the battery.

7. Turn the front fog light on.

8. Adjust the front fog light by turning the adjusting screws as shown in the figure. Loosen the screws first, then tighten them.



Note
  • If the adjusting screws are tightened first, then loosened, they will continue to loosen when the vehicle is in motion and may cause the front fog lights to become misaligned.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.