Mazda 6 Quiz
Body electrical system

High-mount brake light removal/installation

In this manual: Body electrical system
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
4SD In-vehicle-type

1. Disconnect the negative battery cable.

2. Remove in the order indicated in the table.



3. Install in the reverse order of removal.

Rear spoiler type

1. Disconnect the negative battery cable.

2. Remove the rear spoiler. (See REAR SPOILER REMOVAL/INSTALLATION)

3. Remove in the order indicated in the table.



4. Install in the reverse order of removal.

High-mount brake light removal note

Tie a string to the end of the connector of the high-mount brake light beforehand so that the connector can be passed easily through the rear spoiler during installation.


5HB


1. Disconnect the negative battery cable.

2. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION)

3. Remove in the order indicated in the table.



4. Install in the reverse order of removal.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.